Part 2: Reduce Clearance–The Lomakin Effect
Welcome back to our series on upgrading pumps with composite materials. In part 1, we discussed how using composite materials like Vespel® CR-6100 in your pumps allows you to eliminate the metal-to-metal contact points in the pump and minimize the risk of pump seizure:
- In the shop during assembly
- In the field during alignment
- During slow-roll, start-up, and shut down
- During off-design events like dry-running or low flow
Part 2: Reducing Clearance-The Lomakin Effect
Minimizing the risk of seizure in your pump sets the stage for reducing the clearance at the wear parts in your pump. Reducing clearance can be a significant pump reliability upgrade due to a phenomenon known as the “Lomakin Effect“.
Your Wear Rings are Bearings
During pump operation, the flow created by differential pressure across the wear parts in the pump (wear rings, throttle bushings) creates a force called The Lomakin Effect. The force arises from an unequal pressure distribution around the circumference of the component during periods of rotor eccentricity. This force counteracts shaft deflection in the pump.
Figure 1 shows how shaft deflection creates this force. As the fluid enters the clearance between the rotor and wear component, it accelerates as it passes from the high pressure end to the low pressure end. Due to the eccentricity of the rotor, there is more clearance on one side of the wear part than the other. There will be more flow and a locally higher velocity on the side of the wear ring with more clearance and lower velocity on the side of the ring with less clearance. Higher velocity results in lower pressure; lower velocity results in higher pressure, creating a net corrective force which acts in the direction opposite of the shaft deflection. In other words, when your pump experiences shaft deflection, there is a hydraulic “stiffness” (Lomakin Stiffness) which is generated to counteract the shaft deflection.
Using Vespel® CR-6100 you can typically reduce the clearance at the pump wear rings by 50% compared to the API recommended minimum for metal wear parts. The Lomakin Stiffness is inversely proportional to clearance; therefore, a 50% reduction in clearance doubles this force. Potential benefits for your pumps include:
- Less shaft deflection
- Lower vibration levels
- Fewer mechanical seal leaks
- Longer bearing life
The Lomakin Effect is generally beneficial to all centrifugal pumps, but some pump types often show significant vibration reductions and reliability improvements with reduced clearance:
- Multi-stage horizontal pumps
- Older overhung pumps with long, thin shafts (high L/D ratios)
- Two-stage overhung pumps
Reducing the clearance at the wear components can be a major reliability upgrade for your pumps. The reduced clearance increases The Lomakin Effect which improves pump rotor stability. The net result is a pump which runs with potentially lower vibration, fewer seal leaks, and longer bearing life.
Reducing the clearance also increases pump efficiency, which we will discuss in Part 3.
Until then, if you are working on a pump with a long, thin, flexible rotor, contact Boulden to discuss upgrading the wear parts to Vespel® CR-6100 and reducing the clearance. We have a huge stock of Vespel® CR-6100 standard sizes in the USA, Europe, and Singapore available for immediate delivery to your workshop.
For application and installation details, download the Boulden Installation Guide for Vespel® CR-6100