Upgrading Pumps With Composite Wear Components Part: 9

Upgrading pumps with composite wear componentsPart 9: Vertically Suspended Pumps with Separate Discharge (API Type VS4)

Review

Last week, we looked at vertically suspended pumps with the discharge through the column. This week, we take a look at vertically suspended pumps with a separate discharge (API Type VS4).

Vertically suspended pumps with separate discharge are generally used for sump pumps or wastewater pumps. It seems that these pumps cause headaches at most plants. The shaft bushings wear out leading to chronic repairs. Over the years, Vespel® CR-6100 has been used in a lot of these pumps, sometimes the pump life has been extended from a few months to several years; sometimes the pump life has not improved. Therefore, it is important to identify the failure mode before making the upgrade. We have used our experience to create the roadmap below.

Define the Service

The first step is to clarify “sump pump” or “waste water pump”, which are generic terms encompassing a wide range of services. Some services are pumping primarily chemicals mixed with water, and some of them are pumping primarily water mixed with dirt. Some of the sumps are so dirty, that the pump suction strainer seems to be immersed in mud. Another variable is that the shaft bearings are flushed with different arrangements. Some of them are flushed with the process fluid, others with clean water, and others are greased.

Given the range of service conditions, there are several different problems which can cause the shaft bearings to fail. However, there are some commonalities. First, by design, the shaft bearings are along the column of the pump with a separate discharge for the process fluid. The bearings can run dry at start-up until the flushing fluid arrives. Sometimes, the external water flush is turned off; sometimes the flush lines from the process fluid are plugged; sometimes the grease supply runs out. In a chemical sump, the mix of chemicals can cause corrosion with metal wear parts. Finally, in very dirty sumps where the bearings are flushed with the process fluid, abrasive wear tends to be the main problem.

The Road Map

Considering the above, we have created the following table to guide your selection of where to use Vespel® CR-6100 in sump pump services:

Vespel CR-6100 sump pump services.

Vespel CR-6100 sump pump services.

*Some of the alternatives to consider are switching to a clean water flush or looking at an abrasive resistant, non-seizing combination for the shaft bushings and sleeve. This generally entails a hardened sleeve and an abrasive resistant bushing material. If you have any doubts about whether Vespel® CR-6100 is a good fit for your service, contact Boulden to discuss.

Vertical Pump Conclusion

To finish our discussion of vertically suspended pumps, we will talk about assembly and installation issues which impact pump reliability. Until then, use the above information as a guide on how to use Vespel® CR-6100 in your pumps with a separate discharge. If you need any material, contact Boulden. We have whatever size and quantity you need in stock and ready for immediate delivery.

For information on how to install Vespel® CR-6100 into nearly any centrifugal pump type, download the Boulden Installation Guide.

Contact Us Today To Learn More About Vespel and Boulden Company!

Contact Us Today To Learn More About Vespel and Boulden Company!

fbintw

ytg

Today’s Photo

Late Night Snack, Thailand

Late Night Snack, Thailand

 

 

 

 

 

 

 

Boulden Company

Conshohocken, PA, USA

1-610-825-1515

 

Boulden International, S.ar.L

Ellange, Luxembourg

+352 26 39 33 99